I put the TORRAS OrigArmor Prime screen protector on a friend’s iPhone 18 Pro. The tray lines up the glass, but there’s one thing I’d do differently if you’re in the habit of cleaning the phone first: get the phone settled in the tray before the final dust check. That way you don’t have to pick up a freshly cleaned phone and set it down again.
Disclosure: TORRAS sent me this screen protector for free to try.
What’s in the OrigArmor Prime kit
The OrigArmor Prime kit for the iPhone 18 Pro comes with one protector, the guided tray, and a cleaning kit. Lay the parts out before you start. I used the wet wipe first, the microfiber cloth to dry the screen, and the dust sticker to lift anything left behind. The 18 Pro and 18 Pro Max use different sizes, so check which one you ordered before opening the glass.
Seat the phone and make one last pass for dust
I cleaned the phone in the video and then seated it in the tray. Looking back, I’d seat it first and finish cleaning it there. Handling it again can leave a fresh fingerprint or give dust time to settle on the glass.
Use the sticker to dab up individual specks rather than wiping the whole screen again. I checked one more time right before attaching the protector. That last check is when you can still get at a piece of lint without lifting the glass.

Hook the guide, pull the tab, and run the slider
Raise the lever at the top of the tray, hook the top tab, then line up and clip the two holes at the bottom. Check both ends before you pull anything. If one of the holes isn’t seated, stop and line it up instead of forcing it.
Once it was hooked in, I pulled the orange tab to remove the backing. Then I ran the orange slider down the tray and back up. After that I peeled the guide back and checked the glass. This kit has its own tab and slider, so follow its order rather than assuming it works like an older TORRAS applicator.

Check the edges before putting the case back on
I looked at the finished edge and ran my finger over it. The rounded edge felt smooth. I put my friend’s existing TORRAS case back on and could see a small gap between the protector and the case. That’s the fit I saw with this particular setup. I wouldn’t assume every case will leave the same gap.

What makes the Prime different?
This is anti-reflective tempered glass, not a matte film. TORRAS’s specifications list rounded 3D edges, a fingerprint-resistant coating, Face ID compatibility, and less than 0.8% visible-light reflectance. Those are manufacturer specs. In this video I focused on the installation and fit, not a measured glare or scratch test.
TORRAS Glass listed a Black Friday offer for Nov. 20 through Dec. 1, 2026: an extra 10% off eligible orders or 15% on three or more eligible items. Check the sale page and your cart for which items qualify.
If you’re working on an older phone, I also have an iPhone 17 Pro Max TORRAS installation guide. That one covers different protectors and applicators.