I tried the FOXBC 7-1/4-inch three-blade pack and used the 60-tooth blade in my Milwaukee circular saw on a laminate countertop. If you’re buying for a cut that will stay visible, the close-up of the countertop edge is the part of my review I’d watch first. The 24-, 40-, and 60-tooth blades are meant for different jobs, and I didn’t run all three through the same countertop.
Affiliate disclosure: As an Amazon Associate I earn from qualifying purchases. If you buy through the link below, I may earn a commission at no extra cost to you.
See the FOXBC 24T, 40T and 60T combo pack on Amazon
What I’d use each blade for
- 24 teeth: This is the one I’d reach for when cutting framing lumber or making other rough cuts in wood where the edge won’t show. It has the widest spacing between teeth in the set.
- 40 teeth: This is the middle option. I’d start here for general shop work or plywood where the edge matters but I’m not trying for the finest possible finish.
- 60 teeth: This is the one I picked for the laminate countertop. If the cut will stay visible, I’d start with this blade and make a trial cut on an offcut of the same material first.

What the countertop test shows

The video shows the 60-tooth blade in use and then the cut edge up close. I’d look at the laminate face where it meets the cut, not just the face of the material from a few feet away. That close-up is useful for judging this particular cut. It doesn’t tell me how the 24- or 40-tooth blade would have done on the same countertop, or how long any of the blades will stay sharp.

Check your saw before you buy
The pack shown in my review is listed as 7-1/4 inches with a 5/8-inch arbor and a diamond knockout. Check the blade diameter, arbor shape, and speed rating against your own saw’s manual. Milwaukee is the brand of saw I used, not a blanket fit guarantee. The YouTube description links to the three-pack, Amazon ASIN B0FB2KPY8T. That’s the listing to look for if you want all three tooth counts.
Is the three-pack worth getting?
I’d get the combo pack if I had rough lumber, plywood, and visible finish cuts on the project list. If I only needed to make one laminate countertop cut, I’d look for a compatible fine-finish blade rather than buy two extra blades I might not use. For more hands-on tool reviews, see my written and video reviews.